UPDATE 6-Mar-13: The LCD mysteriously stopped working and the backlight also doesnt work anymore.I tried to *gently* pry the backlight PCB from the screen,but ended up damaging the flex cable in between.Arrgh.So thats useless now.
I'm going to try and write & document my work more often from now on.Anyway,getting on with the post,
So the idea here is to develop a custom component for a Nokia 1110 LCD I purchased recently.
As for the hardware,I planned to etch a breakout board,but the fine pitched connector leads stalled execution.
The software part,is basically a form of 9bit SPI.Now,I could use the SPIM component in PSoC Creator,but I'll take this chance to write a custom component where the 9bit shifting will be done via a small verilog module.(If you have a PSoC3/5,and you bitbang,you have sinned.So no bitbang.)
After some googling,I think the LCD I have is 96x65,and uses the PCF8814[pdf datasheet] controller,which does support I2C,but when used with these LCDs,does not have those pins broken out)
Also,theres the whole issue of a backlight,but I'll look into designing the backlight driver later.
I'll start by wiring up the LCD to my trusty PSoC board,according to the pinout below:
With that done,I'll maybe test it by running some init routines,and then detail that effort in Part-2 of this post. :)
PS:I'm not entirely sure if I have the 1110 LCD or the 3310 LCD.I'll try some code and let you guys know.
I'm going to try and write & document my work more often from now on.Anyway,getting on with the post,
So the idea here is to develop a custom component for a Nokia 1110 LCD I purchased recently.
As for the hardware,I planned to etch a breakout board,but the fine pitched connector leads stalled execution.
The software part,is basically a form of 9bit SPI.Now,I could use the SPIM component in PSoC Creator,but I'll take this chance to write a custom component where the 9bit shifting will be done via a small verilog module.(If you have a PSoC3/5,and you bitbang,you have sinned.So no bitbang.)
After some googling,I think the LCD I have is 96x65,and uses the PCF8814[pdf datasheet] controller,which does support I2C,but when used with these LCDs,does not have those pins broken out)
Also,theres the whole issue of a backlight,but I'll look into designing the backlight driver later.
I'll start by wiring up the LCD to my trusty PSoC board,according to the pinout below:
| Pin | Function | |||||
| 1 | VCC | |||||
| 2 | #RESET | |||||
| 3 | DATA | |||||
| 4 | CLK | |||||
| 5 | #CS | |||||
| 6 | VCC | |||||
| 7 | NC | |||||
| 8 | GND | |||||
| 9 | VLED- | |||||
| 10 | VLED+ |
PS:I'm not entirely sure if I have the 1110 LCD or the 3310 LCD.I'll try some code and let you guys know.
